You have to activate javascript for this to work

Settings:

GCode:

Filament Diameter: Diameter of the used filament in mm Nozzle Diameter: Diameter of the nozzle in mm Nozzle Temperature: Nozzle Temperature in °C Nozze Line Ratio: Ratio between nozzle diameter and extruded line width. Should be between 1.05 and 1.2 Bed Temperature: Bed Temperature in °C Use mm/s for speeds: Use mm/s instead of mm/min Slow printing speed: Slow printing speed Fast printing speed: Fast printing speed Movement Speed: Movement speed Retraction Distance: Retraction distance in mm Bed size X: Size in mm of the bed in X Bed Size Y: Size in mm of the bed in Y Layer Height: Layer Height in mm Extrusion Multiplier: Usually 1.0 Start value for PA: Start value for the Pressure Advance. Usually 0 but for bowden setups you might want to start higher, e.g. 0.5 End value for PA: End value of the Pressure Advance. Bowden setups may be closer to 1.000 If there is no significant improvement with a pressure advance up to 1.000, then pressure advance is unlikely to improve the quality of prints. Pressure Advance Stepping: Stepping of the Pressure Advance in the test pattern. The default bed size only supports 35 total steps.